Table of Contents
Advertisement
4-38
Manual rebuilding
Procedures
1.
Replace a hard disk and turn on the controller.
2.
Start MegaRAID Configuration Utility to check each setting parameter.
3.
Select "Rebuild" from the TOP menu to display the "Rebuild – PHYSICAL DRIVES SELECTION MENU"
screen shown below.
4.
Move the cursor onto the hard disk displaying "FAIL," and then press Space to select it.
Multiple hard disks can be selected (simultaneous rebuilding.)
5.
The "FAIL" display for the hard disk selected starts blinking.
6.
When hard disk selection is completed, press F10 to start rebuilding.
7.
A confirmation screen for execution appears. Select "Yes" to start rebuilding.
8.
When the meter display in the "Rebuild Physical Drives in Progress" screen indicates 100%, rebuilding is
completed.
9.
Press Esc to return to the TOP menu and exit MegaRAID Configuration Utility.
Replace hard disk
Start MegaRAID Configuration Utility
Execute rebuilding
Exit MegaRAID Configuration Utility
Advertisement
Table of Contents
