Mitsubishi Electric F700 Instruction Manual page 65

Start and stop using terminals (External
operation)
9.
Turn to show the selected
frequency, "
The frequency flickers for about 5s.
10.
While the value is flickering,
press to set the frequency.
If you do not press
for about 5s and the display then returns
to (display) Hz.
At this time, return to "Step 8" and set
the frequency again.
After about 3s of flickering of the value,
the indication goes back to "
11.
Start acceleration
Turn ON the start switch (STF or STR).
The frequency on the indication increases
by the Pr.7 Acceleration time, and "
(30.00Hz) appears.
[FWD] indication is lit during forward rotation,
and [REV] indication is lit during reverse rotation.
CAUTION
When both of STF and STR signals are turned
ON, the inverter cannot start.
If both are turned ON while the inverter is
running, the inverter decelerates to a stop.
12.
To change the set frequency, perform the operation in above steps 9 and 10.
(Starting from the previously set frequency.)
13.
Deceleration
Turn OFF the start switch (STF or STR).
The frequency on the indication
decreases by the Pr. 8 Deceleration time,
and the motor stops rotating with
" " (0.00Hz) displayed on the indication.
REMARKS
· Pr. 178 STF terminal function selection must be set to "60" (or Pr. 179 STR terminal function selection must be set to "61").
(all are initial values)
· When Pr. 79 Operation mode selection is set to "3", multi-speed operation (refer to page 59) is also valid.
When the inverter is stopped by
displayed alternately.
1. Turn the start switch (STF or STR) off.
2. The display can be reset by
58
Operation
" (30.00Hz).
,the value flickers
" (monitor display).
constant speed
"
Stop
of the operation panel (FR-DU07),
Display
Flicker ··· Frequency setting complete!!
After 3s, the monitor display appears.
Forward
rotation Reverse
rotation
ON
Forward
rotation Reverse
rotation
OFF
.
Flickers for about 5s
Stop
and
Flickering
are