Mitsubishi Electric F700 Instruction Manual page 40

(2) Connection with the MT-HC (75K or more)
MC
MCCB
Three-phase
AC power
supply
*1 Remove the jumper across terminals R-R1, S-S1 of the inverter, and connect the control circuit power
supply to the R1 and S1 terminals. The power input terminals R/L1, S/L2, T/L3 must be open. Incorrect
connection will damage the inverter. (E.OPT (option fault) will occur. (Refer to page 112.)
Do not insert the MCCB between terminals P/+ − N/- (P/+ − P/+, N/- − N/-). Opposite polarity of terminals
*2
N, P will damage the inverter.
*3 Use Pr. 178 to Pr. 189 (input terminal function selection) to assign the terminals used for the X10 (X11) signal.
(Refer to the chapter 4 of the Instruction Manual (applied).) For communication where the start command is
sent only once, e.g. RS-485 communication operation, use the X11 signal when making setting to hold the
mode at occurrence of an instantaneous power failure. (Refer to the chapter 4 of the Instruction Manual
(applied).)
*4 Connect the power supply to terminals R1 and S1 of the MT-HC via an isolated transformer.
*5 Be sure to connect terminal RDY of the MT-HC to the X10 signal or MRS signal assigned terminal of the
inverter, and connect terminal SE of the MT-HC to terminal SD of the inverter. Without proper connecting,
MT-HC will be damaged.
CAUTION
⋅ Use sink logic (initial setting) when the MT-HC is connected. The MT-HC cannot be connected when source logic is
selected.
⋅ The voltage phases of terminals R/L1, S/L2, T/L3 and terminals R4, S4, T4 must be matched.
⋅ When connecting the inverter to the MT-HC, do not connect the DC reactor provided to the inverter.
MT-HCL01 MT-HCB
R R2
R2 R3
S S2
S2 S3
T T2
T2 T3
88R
88S
R1 S1
Connection of stand-alone option units
MT-HCL02 MT-HC
R3 R4 R4
S3 S4 S4
T3 T4 T4
88R P
88S N
RDY
R
RSO
S
SE
T
R1 S1
MT-HCTR
Isolated transformer
Inverter
Motor
R/L1 U
*1 IM
S/L2 V
T/L3 W
P/+
*2
N/
*5
X10
*3
RES
SD
*1
R1/ S1/
L11 L21
*4
33
2