Procedure 2B - Add / Modify A Manager User Credentials - Kaba EX3600 Operation Manual

Required User Level: Master, Manager
1. Put the lock into LearnLok
Manager credential) #
2. Enter command 100# to add / modify a User Access Credential.
3. Enter the User ID location NNN followed by # - NNN#, we use 023# for example
(Range = 001 to 300).
4a. Card Only Mode: After 100# 023# entry, present this user's card close to the
(black) card reader of lock; the green LED flashes indicating that the card has
been enrolled (added); enter # which confirms that this user is not assigned a
PIN. You can add more cards by entering the next user's ID location (NNN#)
followed by presenting this next user's card and then #; add up to 300 cards, if
desired.
Enter a last # to indicate the end of the programming.
Example of Complete Entry for user ID=023:
100#023# Present card # # .
4b. PIN & Card Mode: Procedure is similar to step 4a above, but after enrolling the
card you must not enter the # but continue with assigning the user's PIN (4 to
8 digits as configured initially).
Example of Complete Entry for user ID=023 and PIN=1234:
100#023# Present card (no # entry here) 1234# 1234# (to re-confirm) # .
In the first example above, this user's card will open the lock with PIN assigned
(card only mode), or in the second example above, the lock will open on
entering the PIN first (1234) followed by presenting the associated card (PIN &
card mode).
PROCEDURE 2B - ADD / MODIFy A MANAGER USER CREDENTIAL
The procedure to add a Manager user is exactly the same as adding a regular Access user
except for the different 3-digit command code 101 (instead of 100) usage. Also, only the
Master can add, delete, etc, of the Manager users.
Required User Level: Master
1. Put the lock into "LearnLok
2. Enter command 101# to add / modify a Manager User's Access Credential
3. Enter the User ID location NNN followed by #: NNN#; we will use 015# for
example (Range = 001 to 300)
4a. Card Only Mode: After 101# 015# entry, present this Managers card close to
the (black) card reader of the lock; the green LED flashes indicating that the
card has been enrolled (added); enter # which confirms that this manager user is
not assigned a PIN. You can add more cards by entering the next user's ID loc-
ation (NNN#) followed by presenting this next manager user's card and then #;
add up to 300 cards, if desired.
Enter a last # to indicate the end of programming.
Example of Complete Entry for manager user ID=015
101# 015# Present card # # .
16
TM Pushbutton Programming Mode. -> # Master PIN (or
TM " Pushbutton Programming Mode.