Procedure 2 - Add / Modify A Manager Access Code; Procedure 3 - Add / Modify Service User Access Code - Kaba E-Plex 5000 Operation Manual

Procedure 2 - Add / Modify a Manager Access Code

Each time you add a Manager access to a door, you must program the
door with a Manager Access Code. If you change the Access Code for
an existing Manager, the procedure is the same.
Required User Level: Master
1. Put the lock into Pushbutton Programming Mode.
2. Enter command 101# to add / modify a Manager
Access Code.
3. Enter the User ID location (a three-digit number you have on a
list that you should carry with you) followed by #, for example 024#.
4. Enter UUUUUUUU#, representing a User Access Code of
between 4 and 8 numbers, depending on the length of Access
Code that you selected in Procedure 1 on page 7. For example,
if your code length is 8 digits, it could be 00001224#.
5. Enter the code 00001224# again.
6. Example of Complete Entry: 101#024#00001224#00001224#.
7. Enter another # to indicate the end of programming.
8. The Manager Access Code 00001224 will now work in that door
with all the access privileges assigned to a Manager User.
9. Manager Users can open the door by just entering the Access
Code without the # signs, or put the lock into Pushbutton
Programming Mode by entering # before and after their
Access Code.

Procedure 3 - Add / Modify Service User Access Code

A Service User is any person who needs access to the lock for a limited
time period in order to perform a service, such as painting or repairs in
the room or area. A Service User Access Code allows the service person
to enter, exit and re-enter using that code for a certain number of hours.
Required User Level: Master, Manager
1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 102# to add / modify a Service User Access Code.
3. Enter the Service User ID location (a three-digit number you
have on a list that you should carry with you) followed by #, for
example 025#.
16