Table of Contents
Advertisement
M-Unit User - There can be also M-Unit (Maintenance Unit) users and Guest users in the
lock, available only if the E-Plex Enterprise software is used - sold separately.
Note: The total number of users enrolled into the lock at any given time cannot exceed
300, plus the Master user. You can enroll a user mix of Access, Manager and Service
users but the total aggregate of users cannot exceed 300 users.
USER CREDENTIALS
Each time you add a user to give access to a door, you must program the lock at the key-
pad with an Access Credential for this user who may be a Manager user and/or an Access
user and/or a Service user. This user access credential can be either card only, or PIN
followed by card for Manager and regular Access users; and can be PIN only the Service
users. The global Master user's access will always be an 8-digit PIN only. You can also
easily delete the access credential for an existing user right at the lock keypad.
Credential to Access the Lock:
Credential of the Master User: (i) PIN only access - no expiry
Credential of a Manager User: (i) Card only access; or,
Credential of an Access User: (i) Card only access; or,
Credential of a Service User: (i) PIN only access -> with either (a) no expiry, or
(b) 1 through 96 hours access, or (c) one time entry only ("one shot")
Credential to Program the Lock:
Programming Sequence of Master User: #Master PIN# complete command
code sequence ##
Programming Sequence of Manager User:
In Card only mode: # present card (green LED flashes) complete com-
mand code sequence ##
In PIN & Card mode: # PIN # present card (green LED flashes) complete
command code sequence ##
14
(ii) PIN & card access -> no expiry
(ii) PIN & card access -> no expiry
Advertisement
Table of Contents
