Procedure 7B - Delete All User Credentials Except Master & Manager(S); Procedure 8B - Activate Access User Credentials - Kaba EX3600 Operation Manual

PROCEDURE 7B - DELETE ALL USER CREDENTIALS EXCEPT
All credentials may be deleted together if you are changing everything because of, for
example, suspected theft of credentials. *Warning*: be sure that you want to do this,
because manually re-enrolling hundreds of credentials for all the users again will be time
consuming at the lock keypad.
Required User Level: Master, Manager
1. Put the lock into "LearnLok
(or Manager credential) #
2. Enter Command 299# to delete all users except the Master and the Managers.
Enter a last # to indicate the end of programming.
Example of Complete Entry:
299# # .
You have now deleted all regular Access and Service user credentials, allowing
you to re-assign those deleted credentials to the same or new users.

PROCEDURE 8B - ACTIVATE ACCESS USER CREDENTIALS

A User credential should be re-activated if it had been de-activated earlier - for instance
during a users' vacation. Any user's credential that was inactive but is needed to be back
in service again can be easily re-activated as described in Procedure 13B.
Required User Level: Master, Manager
1. Put the lock into "LearnLok
2. Enter Command 300# to re-activate an Access user's credential; you do not need
this person's PIN and/or card to do this.
3. Enter this user's ID location (001 through 300); we will use the ID location 023 in
this example.
Enter a last # to indicate the end of programming.
Example of Complete Entry for user ID=023:
300#023# #.
You have now activated this Access user's credential which was temporarily
de-activated.
MASTER & MANAGER(S)
" Pushbutton Programming Mode -> # Master PIN
TM
" Pushbutton Programming Mode -> # Master PIN #
TM
21