Sample Printouts - Sartorius CH1NE Operating Instructions Manual

Sample Printouts

For details on the individual information
blocks, see "Configuring Printouts" above.
For details on configuring the header
lines, refer to the chapter describing the
particular application.
Weighing Application
There is no data for the "initialization
data" block. If this block is enabled
for the printout, a blank line is output.
HEADER LINE 1
HEADER LINE 2
14.01.2002 09:43
--------------------
G# + 1.402 kg
T + 0.200 kg
N + 1.202 kg
--------------------
With weighing instrument serial number:
Ser.no. 80705337
G# + 1.402 kg
T + 0.200 kg
N + 1.202 kg
--------------------
Counting Application
The "Initialization data" block contains the
reference sample quantity and reference
piece weight. The "Results" block contains
gross, net and tare weights, as well as the
calculated piece count.
--------------------
nRef 10 pcs
wRef + 0.035 kg
G# + 1.402 kg
T + 0.212 kg
N + 1.190 kg
Qnt 34 pcs
--------------------
Neutral Measurement Application
The "Initialization data" block contains
the reference sample quantity and
reference weight. The "Results" block
contains gross, net and tare weights,
as well as the calculated piece count.
Ref 2 o
wRef + 1.200 kg
G# + 14.700 kg
T + 0.300 kg
N + 14.400 kg
Qnt 12 o
--------------------
Weighing in Percent Application
The "Initialization data" block contains
the reference percentage and reference
weight. The results block shows gross,
net and tare weights, as well as the
percentage, which is shown as either the
loss or the residual amount.
Percentage = residue:
--------------------
pRef 100 %
Wxx% + 2.100 kg
G# + 1.859 kg
T + 0.200 kg
N + 1.659 kg
Prc 79 %
--------------------
Percentage = loss:
--------------------
pRef 100 %
Wxx% + 2.100 kg
G# + 0.641 kg
T + 0.200 kg
N + 0.441 kg
D 21 %
--------------------
Checkweighing Application
The "Initialization data" block contains
the nominal, minimum and maximum
weights. The "Results" block always
contains the gross, net and tare
weights. The other results can be dis-
played in one of two ways:
– Result = Weight:
The deviation from the nominal weight
is given both as a percentage and as
an absolute (weight) value, whether the
result lies within the tolerance limits
or not.
– Result = Threshold status:
If the result lies within the tolerance
limits, the printout shows the deviation
from the nominal weight both as a
percentage and as an absolute (weight)
value, just as in the "Weight" printout
mode described above.
If the result is outside the tolerance lim-
its, the last line of the printout indicates
the status as follows:
Result in "OK" range; "Weight" or
"Threshold" printout:
--------------------
Setp + 1.300 kg
Min + 1.235 kg
Max + 1.365 kg
G# + 1.312 kg
T + 0.000 kg
N + 1.312 kg
Lim + 0.92 %
W.Diff+ 0.012 kg
--------------------
Result outside (over) the "OK" range;
"Threshold" printout:
--------------------
Setp + 1.300 kg
Min + 1.235 kg
Max + 1.365 kg
G# + 1.400 kg
T + 0.000 kg
N + 1.400 kg
Stat HH
--------------------
91