Installing The Cable Guide (Optional); Rack-Mounting The Chassis - Cisco 4948 - Catalyst Switch Installation Manual

Rack-Mounting the Chassis

Note
Figure 3-2
1
1
1

Installing the Cable Guide (Optional)

One cable guide is provided in the accessory kit. The cable guide attaches to the rack-mount bracket
using a single M4 screw (a threaded M4 hole is provided in the rack-mount bracket). The cable guide is
designed to be used when the rack-mount brackets are attached to the front of the chassis and can be
attached to either the left side or the right side of the chassis.
If the chassis is mounted to the rear posts of the equipment rack, the cable guide cannot be installed.
Note
Catalyst 4948E and Catalyst 4948E-F Switch Installation Guide
3-8
Figure 3-2 (top view) shows how to install a chassis in a rack when the chassis has the
rack-mount brackets attached at the front of the chassis.
install a chassis in a rack when the chassis has the rack-mount brackets attached at the rear of
the chassis.
Installing the Chassis in the Rack
2
2
12-24 or 10-32 screws (2 per bracket)
Chapter 3
Figure 3-2 (bottom view) shows how to
2 Equipment rack post
Installing the Switch
OL-21561-02