Installing a Compact Switch
Figure 44: Locking the Retainer Clamp
1
Installing the Cable Guard (Optional)
The cable guard prevents tampering with the cables after they are installed. The cable guard
(C9K-CMPCT-CBLE-GRD=) is not included with the switch, but you can order it from your Cisco
representative.
Note
The cable guard is shipped with the following items:
• Two 10-32 Phillips pan-head screws
• Two 8-18 Phillips pan-head screws
Procedure
Step 1
Use the supplied 10-32 pan-head screws to attach the cable guard to the switch.
Pressing the tabs on the
retainer clamp
You can use the cable guard when the switch is mounted on a wall.
-
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
Installing the Cable Guard (Optional)
-
71