Toshiba DP5000-Series User Manual page 56

Sequence" heading. Some features require additional input, such as:
To transfer a call directly to Voice Mail (VM)
1. While on a call, press
• Dest. Ext. or Telephone No. – Call Forward destination numbers can be
internal extension numbers or outside telephone numbers. If the destination is
2. Enter .
#407
an outside number, enter the access code used for dialing out (such as
3. Enter the VM mailbox number (usually the same as the extension number) +
telephone number +
4. Hang up and the caller is connected to the VM mailbox. This feature does a blind
its.
transfer to VM.
• Timer – Enter the number of seconds (08~60) your telephone should ring
To transfer a call directly to VM with a DSS button
before forwarding the call. (This is the Call Forward-No Answer timer.)
1. While on a call, press
• Call Forward Pass Code – A four-digit Call Forward pass code can be setup
2. Press the DSS button programmed to the voice mail number.
by your System Administrator and will allow one station to activate the call
3. Hang up and the caller is connected to the VM mailbox.
forward setting for another station. Users must enter the Call Forward pass
code for the station to be forwarded.
Note In Table 15 on Page
tion tone and will play at that point in the sequence to confirm your input was
accepted.
Press
(Hold)
your station (the Line LED flashes green - incoming call)....or if your telephone
has the Auto Hold feature, just press the flashing extension button.
(Cnf/Trn)
. The CIX accepts destination numbers of up to 32 dig-
#
(Cnf/Trn)
105, (tone) refers to three short tones used as a confirma-
. The existing call is placed on hold. The camped-on line rings
.
.
Strata CIX DP5000-series Telephone UG
) + the
9
.
#
01/08