Running Belt Adjustment; Lubrication - Life Gear 97430 Owner's Manual

Running Belt Adjustment:

The running belt is adjusted at the factory; it may come loose during
transportation and from use. After prolong use of running, the belt will stretch
out. If the running belt is shifting to the left, turn on the main power switch of
treadmill and let the running belt run at the speed of 2~3 km/h. Using the hex key
provided, turn the left rear roller adjustment bolt 1/4 turn in the clockwise direction.
You should see the belt start to correct itself by moving back toward the center. Repeat
the above procedure until the running belt is centered. If the running belt is shifting to
the right, turn on the main power switch of treadmill and let the running belt run at the
speed of 2~3 km/h. Using the hex key provided, turn the right rear roller adjustment
bolt 1/4 turn in the clockwise direction. You should see the belt start to correct itself by
moving back toward the center. Repeat the above procedure until the running belt is
centered. If the running belt is slipping during use, turn off and unplugged the treadmill. Using the hex key provided, turn both left and
right rear roller adjustment bolts 1/4 turn in the clockwise direction for the same distance, turn on the main power switch of treadmill and
let the running belt run at the speed of 2~3 km/h. You should now walk on to the running belt to determine if the running belt is still
slipping. Repeat the above procedure until the running belt is not slipping.

Lubrication:

The treadmills have already been spread with "Silicone Oil" in advance before leaving
the manufacturing plant. Silicone oil is without volatility and has gradually permeated
through the running belt. There will be no need to re-spread the oil in normal
circumstances. To maintain the running belt, we have included a small bottle of
"Silicone Oil". "Silicone Oil" may be re-spread once the resistance has been
increased and the running belt starts rubbing against the running deck. To hold
open the running belt from two sides, apply the silicone oil with an even motion
on the center of the running deck. Allow the silicone oil to 'set' for one
minute before using the treadmill.
Attention: Only use "Silicone Oil" lubricants for this equipment. In addition, do not add
any other oil ingredient; otherwise the treadmill will be damaged. Do not
over-lubricate the walking board. Excess lubricant should be
19
wiped off with a clean towel.