Running Belt Adjustment - Life Gear STEP MAKER PRO 97340 Owner's Manual

Table of Contents

Advertisement

Running Belt Adjustment:

The running belt is adjusted at the factory; it may come loose during transportation and from use.
After prolong use of running, the belt will stretch out. If the running belt is shifting to the left, turn on
the main power switch of treadmill and let the running belt run at the speed of 2~3 km/h. Using the
hex key provided, turn the left rear roller adjustment bolt 1/4 turn in the clockwise direction. You
should see the belt start to correct itself by moving back toward the center. Repeat the above
procedure until the running belt is centered. If the running belt is shifting to the right, turn on the
main power switch of treadmill and let the running belt run at the speed of 2~3 km/h. Using the hex
key provided, turn the right rear roller adjustment bolt 1/4 turn in the clockwise direction. You should
see the belt start to correct itself by moving back toward the center. Repeat the above procedure
until the running belt is centered. If the running belt is slipping during use, turn off and unplugged the treadmill. Using the hex key
provided, turn both left and right rear roller adjustment bolts 1/4 turn in the clockwise direction for the same distance, turn on the
main power switch of treadmill and let the running belt run at the speed of 2~3 km/h. You should now walk on to the running belt to
determine if the running belt is still slipping. Repeat the above procedure until the running belt is not slipping.
Lubrication
The treadmills have already been spread with "Silicone Oil" in advance before leaving the
manufacturing plant. Silicone oil is without volatility and has gradually permeated through the
running belt. There will be no need to re-spread the oil in normal circumstances.
To maintain the running belt, we have included a small bottle of "Silicone Oil". "Silicone Oil" may be
re-spread once the resistance has been increased and the running belt starts rubbing against the
running deck. To hold open the running belt from two sides, apply the silicone oil with an even
motion on the center of the running deck. Allow the silicone oil to 'set' for one minute before using
the treadmill.
Attention: Only use "Silicone Oil" lubricants for this equipment. In addition, do not add any other
oil ingredient; otherwise the treadmill will be damaged. Do not over-lubricate the walking board.
Excess lubricant should be wiped off with a clean towel.
15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents