Logging Console; Logging Filesavetime - Zte ZXR10 Command Manual

Syntax
Description
This example describes how to set the interval time of writing cmd
Example
log to 100 minutes.
ZXR10(config)#logging cmdlog-interval 100

logging console

Use this command to send the alarm messages to the console COM
Function
interface or telnet terminal. Cancel the setting with the no com-
mand.
Global configuration
Command Mode
logging console <level>
Syntax
no logging console
Syntax
Description
�
Instructions
�
�
This example describes how to send the alarm messages with level
Example
5 and above to the console serial interface,
ZXR10(config)#logging console warnings

logging filesavetime

Use this command to set the time for writing alarm log into file
Function
and sending to the FTP server. Cancel the setting with the no
command.
Global configuration
Command Mode
logging filesavetime interval <time>| everyday <time>|
Syntax
week <weekday><time>| month <mothday><time> [vrf
<minute>
<level>
<map-name>
After the system initialization, the alarm messages with the
level of notifications are sent to the COM interface.
Run the logging on command before this command. The no
command stops sending the alarm messages to the COM in-
terface. The alarm message output can be opened (closed)
with the (no) terminal monitor command on the console COM
interface or telnet terminal.
filter <map-name>command can be used after this command,
which filters a certain alarms. To configurefilter <map-name
>use command logging filter-map
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 5 System Log/Statistics Management
The time interval(in minute), in the range of
10~65535. By default, it is 2880 minutes.
Alarm level (1: emergencies; 2: alerts;
3: critical; 4: errors; 5: warnings; 6:
notifications; 7: informational; 8: debugging)
Alarm filter table name
67