Multi-User Configure - Zte ZXR10 Command Manual

ZXR10 Command Manual (Basic Configuration Volume I)
Function
Command Mode
Format
Instructions
Example
Related Command
16 Confidential and Proprietary Information of ZTE CORPORATION
If you execute the command successfully,
any other operation is invalid except power-off.
[yes/no]:y
.. OK!You can power off the machine later.
ZXR10#
� This example describes how to set power-off manually.
ZXR10# flash-protect
Are you sure to power off the machine?
If you execute the command successfully,
any other operation is invalid except power-off.
[yes/no]:y
.. OK!You can power off the machine later.
ZXR10#

multi-user configure

Use this command to permit multiple users to enter the configura-
tion mode. Configure the single user configuration mode with the
no command.
Global configuration

multi-user configure

no multi-user configure
By default, only a user can enter the global configuration mode.
Use this command to permit other users enter into the global con-
figuration mode. The no command is used to configure the single
user to enter into configuration mode. Make sure that other users
have exited configuration mode, then use no command.
Note:
When multiple users are configuring, their configurations should
not conflict.
� This example describes how to enter the configuration mode
and allow multiple user configurations when there is no user in
the configuration mode.
ZXR10#configure terminal
ZXR10(config)#multi-user configure
%Warning: allow others configure, must avoid conflict.
ZXR10(config)#
� This example describes how to enter the single user configu-
ration mode when there is one user in the configuration mode.
ZXR10#configure terminal
%Simultaneous configs not allowed. Locked from 168.1.168.168
ZXR10#
� This example describes how to do when other users have not
exited the configuration mode.
ZXR10(config)#no multi-user conf
%Someone has entered the configure mode,
cannot set single-user configure!
ZXR10(config)#
configure terminal
power-off