Show Ntp Status; Show Tcp - Zte ZXR10 Command Manual

ZXR10 Command Manual (Basic Configuration Volume I)
Instructions
Example
Function
Command Mode
Syntax
Related
Commands
Function
Command Mode
Syntax
Example
120 Confidential and Proprietary Information of ZTE CORPORATION
� Display all the statistics information of all the protocols (includ-
ing the dynamic routing protocol) on the IP layer.
� The statistics of the IP layer protocol packets include the fol-
lowing contents:
IP statistics: number of received packets, number of sent
�
packets, fragment statistics, and broadcast packet statis-
tics.
ICMP statistics: packets received, and packet sent.
�
ARP statistics: Number of received packets and number of
�
sent packets.
TCP statistics: number of packets received, number of
�
packets with checksum errors, and the number of packets
sent.
UDP statistics: number of packets received, number of
�
packets with checksum errors, and number of erroneous
packets on the receiving port.
URPF statistics: number of packets that are dropped for
�
not passing the URPF check.
� ZXR10 GAR, ZXR10 ZSR, ZXR10 GER, ZXR10 T128 and ZXR10
T1200 support the display of URPF counter.
This example describes how to display the statistics on IP trans-
mission.

show ntp status

Use this command to display the NTP running status.
All modes except exec
show ntp status
ntp enable
ntp server

show tcp

Use this command to display the relevant parameters of all TCP
connections.
All
show tcp
This example describes how to display the relevant parameters of
all the TCP connections.