End; Exit - Zte ZXR10 Command Manual

Example
Related Command
Purpose
Command Modes
Syntax
Example
Related
Commands
Purpose
Command Modes
Syntax
Instructions
Example
Note:
Both commands enable secret 0 <password> and enable secret
<password> are used to enter an unencrypted password. Set the
password with the enable secret 5 <password> command. The
configured password is not an encrypted privileged password un-
less the length of <password> is 24.
This example describes how to set the privilege password to
ZXR10.
ZXR10(config)#enable secret ZXR10
enable

end

Use this command to return to the privileged EXEC mode.
The command is available for all modes other than the EXEC and
privileged EXEC mode.

end

This example describes how to return from the global configuration
mode to the privileged EXEC mode.
ZXR10(config)#end
ZXR10#
configure terminal
interface
router bgp
router ospf
router rip

exit

Use this command to quit the login router or return to the last
mode.
All modes

exit

When it is executed under the EXEC mode or privileged EXEC
mode, it means exiting the login router. While in other modes,
it means returning to the last mode.
This example describes how to exit from the global configuration
mode to the privileged EXEC mode.
ZXR10(config)#exit
ZXR10#
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Basic System Management
13