Traffic-Limit(Global) - Zte ZXR10 Command Manual

ZXR10 Command Manual (QoS Volume)
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
24 Confidential and Proprietary Information of ZTE CORPORATION
in
out
This command is applied to ZXR10 T160G only.
This example describes how to configure the limit rate as 1024 and
the burst size as 2048 on the ingress direction of an interface.
ZXR10(config)#interface vlan10
ZXR10(config-if)#traffic-limit rate-limit 1024 bucket-size 2048 in
show running-config

traffic-limit(Global)

Use this command to configure traffic policing. Delete the config-
uration with the no command.
Global configuration
The command format on ZXR10 T160G and ZXR10 5900:
traffic-limit {<acl-no>|<acl-name>} rule-id <rule-no> cir
<cir-value> cbs <cbs-value>{pir <pir-value> pbs <pbs-value>|
ebs <ebs-value>} mode blind | aware [{[remark-red-dp
<drop-precedence>][remark-red-dscp
ark-yellow-dp
<dscp-value>][forward-red][drop-yellow]}]
The command format on ZXR10 3900/3200:
traffic-limit {<acl-no>|<acl-name>} rule-id <rule-no> cir
<cir-value> cbs <cbs-value>{pir <pir-value> pbs <pbs-value>|
ebs <ebs-value>}[mode blind | aware ][conform {remark-p
oliced-serviced |{[remark-cos][remark-drop-priority]}}][e
xceed {forward | drop}]
no traffic-limit {<acl-no>|<acl-name>} rule-id <rule-no>
For ZXR10 T160G and ZXR10 5900:
<acl-no>|<acl-na
me>
rule-id <rule-no>
cir <cir-value>
cbs <cbs-value>
ebs <ebs-value>
pir <pir-value>
Applies traffic policing in the incoming
direction of the interface.
Applies traffic policing in the outgoing
direction of the interface.
<drop-precedence>]][remark-yellow-dscp
ACL number / ACL name
Rule number in the ACL
Speed limitation, range: 1~32000000
Burst size, range: 1~160006
Optional, the keyword of the action which is
executed after exceeding the flow limitation,
range: 4~16000
Configure the action as "forward" after
exceeding the flow limitation, range:
64~32000000
<dscp-value>][rem