Class - Zte ZXR10 Command Manual

ZXR10 Command Manual (QoS Volume)
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
36 Confidential and Proprietary Information of ZTE CORPORATION
The route-map sets QoS attribute. This command does not check
whether configuring the corresponding route-map already. Only
one bgp-policy command can be set on the interface using cov-
ering mode for the multiple configuration.
This example describes how to configure the aging time to 20
hours.
ZXR10(config)#interface gei_1/1
ZXR10(config-if)#bgp-policy destination precedence
route-map

class

Use this command to set policy class on policy mapping. Cancel
the settings with the no form of this command.
Policy mapping configuration
class <class-map-name>
no class <class-map-name>
<class-map-name>
� Policy mapping includes default policy class, default policy class
named as class_default. The default policy class can not be
deleted with the no class command.
deleted, all policies include the default policy mapping will be
deleted at the same time.
� The class mapping that the parameter <class-map-name>
specifies has to be a created one.
� This command applies to ZXR10 T64E/T128 and ZXR10 GER.
This example describes how to set policy name class_1 in policy
map policy_1 and enter policy configuration mode.
ZXR10(config)#policy-map policy_1
ZXR10(config-pmap)#class class_1
ZXR10(config-pmap-c)#
policy-map
show policy-map

class

Use this command to create the hierarchy policies of H-QoS, and
enter into the next layer of H-QoS configuration mode. Delete the
configuration with the no form of this command.
H-QoS hierarchy policies configuration

class

<class-map-name><bps><burst-normal><burst-max>
conform-action <action> exceed-action <action>
Class mapping name
If policy mapping is