Redirect - Zte ZXR10 Command Manual

ZXR10 Command Manual (QoS Volume)
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
18 Confidential and Proprietary Information of ZTE CORPORATION
<wrr-queue-weight>
dwrr
<schedule-unit>
The queue mode is strict-priority by default.
This command is applied to ZXR10 T160G and ZXR10 5900.
This example describes how to set the strict-priority as the queue
mode.
ZXR10(config)#interface vlan10
ZXR10(config-if)#queue-mode strict-priority
show running-config
show running-config interface

redirect

Use this command to configure the redirection. Delete the config-
uration with the no from of this command.
Global configuration
redirect {<acl-no>|<acl-name>} rule-id <rule-no>{cpu| inte
rface <port-name>| next-hop <ip-address>}
no redirect {<acl-no>|<acl-name>} rule-id <rule-no>
<acl-no>|<acl-na
me>
rule-id <rule-no>
cpu
interface <port-na
me>
next-hop <ip-addre
ss>
Product
ZXR10 T160G
ZXR10 3900/3200
ZXR10 5900
� Both the ACL number and rule id can be used only after being
defined.
Queue weight of WRR mode, 0~15
Not supported
Not supported
ACL number/ACL name
ACL rule number, in the range of 1~100
Be redirected to the CPU.
Be redirected to the specified port.
Specifies the next-hop IP address (for policy
routing).
Parameter Description
<acl-number> is in the range of 1-349,
1000~3499, rule-id is in the range of 1~1000
<acl-number> is in the range of 1-299,
rule-id is in the range of 1~100
<acl-number> is in the range of 1-349,
1000~3499, rule-id is in the range of 1~100