Configuration Programming In The Shipping Box - Bosch Starlight 7000 HD Operation Manual

16 en | Configuration Programming in the Shipping Box
5

Configuration Programming in the Shipping Box

Caution!
Take extra care lifting or moving MIC7000 cameras because of their weight (6.7 kg (14.7 lb)).
!
The camera packaging allows installers to connect the camera to the network and configure
the camera still in the box.
1. Remove the accessories box from the top, middle section of the box.
2. Supply power to the camera and Connect the Camera to the Network, page 28. Note that
the wiper moves one time across the camera window, and then returns to parked position.
3. Configure the camera. Refer to Configuration, page 37 for details.
Note: Do not change the camera orientation to "Inverted" while the camera is still in the box.
The camera head must be free to rotate. If you must change the camera's orientation to
"Inverted," remove the camera from the box and configure it by following the steps in
Configuration Programming on a Temporary Table-top Stand, page 17.
4. Disconnect the wires/cables from the connectors in the base of the camera.
2014.09 | 1.3 | F.01U.291.520 Operation Manual
MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
Bosch Security Systems