Configuring Audio (Optional) - Bosch Starlight 7000 HD Operation Manual

MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
Some changes only take effect after the unit is rebooted. In this case, the Set button changes
to Set and Reboot.
1.
2.
13.3

Configuring Audio (Optional)

Note for MIC7000 cameras only: These options are available only if you have connected a
VIDEOJET connect device (VJC-7000-90) to your camera.
Enabling Audio Transmission
To transmit audio via the IP connection, follow these steps:
1.
2.
3.
4.
Activating Audio Reception
To configure audio via the Web browser, follow these steps:
1.
2.
3.
4.
Notice!
The audio signal is sent in a separate data stream parallel to the video data, and so increases
the network load. The audio data is encoded according to G.711 or L16 and requires an
additional bandwidth of approximately 80 Kbit/s for each connection.
5.
For more information, refer to Audio, page 64.
Bosch Security Systems
Make the desired changes.
Click the Set and Reboot button. The camera reboots and the changed settings are
activated.
Open the LIVE page, and then click the Settings tab.
In the left pane, click Advanced, and then click Web Interface. The Web Interface menu
expands.
Click LIVE Functions. The LIVE Functions page appears.
Click the Transmit Audio radio button to enable for audio.
Open the LIVE page, and then click the Settings tab.
In the left pane, click Advanced Mode, and then click Camera. The Camera menu
expands.
Click Audio. The Audio page appears. The page displays the current video image in the
small window next to the slide controls to help you verify the audio source and improve
the Peak levels.
Select the protocol in the Audio field to activate audio over IP. (Change the option to
ON.)
If you wish to configure the input and output gain of the audio signals, set the Line In and
Line Out fields to suit your specific requirements. Changes are effective immediately. The
current level is displayed next to the slide control to help do this. Make sure that the
display does not go beyond the green zone during modulation.
Operation Manual
Configuration | en 41
2014.09 | 1.3 | F.01U.291.520