Configuration Programming On A Temporary Table-Top Stand - Bosch Starlight 7000 HD Operation Manual

MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
6 Configuration Programming on a Temporary Table-top
Stand
The camera (still in the foam) can stand temporarily on a flat, horizontal surface such as a
desk or a table during initial network connection and configuration.
1. Remove the accessories box from the top, middle section of the box.
2. Remove the camera, still in the foam, from the box. Place the camera upright on a flat,
horizontal surface.
3. Remove the foam covering the head of the camera.
4. Supply power to the camera and Connect the Camera to the Network, page 28. Note that
the wiper moves one time across the camera window, and then returns to parked position.
5. Configure the camera. Refer to Configuration, page 37 for details.
Notice!
If you change the camera orientation to "Inverted" (from the Settings page of the web
browser: Advanced > Camera > Installer Menu > Orientation), then the camera head will
rotate automatically into inverted position (180°). Note that the visor will be near the top of
the body of the camera.
6. Disconnect the wires/cables from the connectors in the base of the camera.
Bosch Security Systems
Configuration Programming on a Temporary Table-top Stand | en
Operation Manual
17
2014.09 | 1.3 | F.01U.291.520