Make Connections - Power And Control; About Camera Power And Control; Power Source Options - Bosch Starlight 7000 HD Operation Manual

MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
10

Make Connections - Power and Control

10.1

About Camera Power and Control

The camera transmits PTZ control commands and images over a TCP/IP network. It also allows
users to configure the camera display settings, camera operating settings, and to configure
the network parameters.
The camera incorporates a network video server in the IP module. The primary function of the
server is to encode video and control data for transmission over a TCP/IP network. With its H.
264 encoding, it is ideally suited for IP communication and for remote access to digital video
recorders and multiplexers. The use of existing networks means that integration with CCTV
systems or local networks can be achieved quickly and easily. Video images from a single
camera can be simultaneously received on several receivers.
10.2

Power Source Options

The camera can be powered by a network compliant to High Power-over-Ethernet (Bosch's
version of High PoE) using a Bosch model of High PoE Midspans (sold separately). With this
configuration, only a single (Cat5e/Cat6) cable connection is required to view, to power, and
to control the camera.
The camera can also accept a standard 24 VAC power source if a High PoE network interface
will not be used. User-supplied wiring must be in compliance with electrical codes (Class 2
power levels).
For maximum reliability, the camera can be connected simultaneously to a High PoE Midspan
and a separate 24 VAC power source. If High PoE and 24 VAC are applied simultaneously, the
camera usually selects auxiliary input (24 VAC) and will draw minimal power from the High
PoE Midspan. If the 24 VAC power source fails, the camera switches power input seamlessly
to High PoE. After the 24 VAC power source is restored, the camera switches power input
again to 24 VAC.
If connected to both power sources, the camera will operate at 24 VAC if High PoE is not
available.
Warning!
Bosch's version of High PoE:
!
If supplying power to the camera by PoE or a midspan device, you must install additional
surge protection.
In the table below, an "X" identifies the power source options for MIC7000 camera models.
CAMERA MODELS
Standard models with
illuminator
Standard models
without illuminator
Extreme low
temperature models
Note: The MIC7000 illuminator accessory is not compatible with the extreme low temperature
models (including MIC-7130-PB4PB, MIC-7130-PW4PB, MIC-7230-PB4PB, and MIC-7230-
PW4PB).
Bosch Security Systems
60 W midspan 95 W midspan
X
Operation Manual
Make Connections - Power and Control | en
VIDEOJET connect
X X
X X
X X
25
24 VAC PSU
X
X
X
2014.09 | 1.3 | F.01U.291.520