Session Timeout; Show Line Config; Transport Input - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Syntax
Description
Instruction
Example
Purpose
Command Modes
Syntax
Syntax
Description
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example

session timeout

Use this command to set the session timeout for a line.
Line Configuration
session timeout <interval>
<interval>
The line connection is cut off when exceeding the set timeout.
This example describes how to set the reverse telnet connection
timeout to 10 minutes on line 2.
ZXR10(config)#line 2
ZXR10(line_config)#session-timeout 10

show line config

Use this command to view some line or all line configuration infor-
mation.
All modes
show line config {all |<begin-port>[<end-port>]}
all
<begin-port>
<end-port>

transport input

Use this command to set transmit protocol data that allowed re-
ceiving.
Line configuration
transport input <telnet>
no transport input <telnet>
<telnet>
It is only applied to telnet connection at present.
This example describes how to configure line 2 to allow telnet pro-
tocol through.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 Reverse Telnet Configuration
Time interval, unit: minute the default is 2
hours. The range is 1-10000 minutes.
View all line configuration information
The first line of a group lines
The last line of a group lines
telnet protocol
41