Lakeshore 332 User Manual page 129

DISPFLD?
Displayed Field Query
Input:
DISPFLD? <field>[term]
Format: n
<field>
Returned: <item>, <source>[term]
Format: n,n
EMUL
330 Emulation Mode Command
Input:
EMUL <off/on>[term]
n
Format:
<off/on>
Remarks: The 330 Emulation Mode allows the remote interface of the Model 332 to be compatible
with Model 330 commands. The 330 Emulation Mode only affects remote operation; front
panel operation of the Model 332 is not changed. In 330 Emulation Mode, curve locations
are mapped to match Model 330 locations. For example, the DT-500-D Curve, found at
curve location 3 in the Model 332, is mapped to location 0 when in 330 mode. This
applies to the following remote commands: ACUR, ACUR?, BCUR, BCUR?. The
following Model 330 commands are not supported in 330 Emulation Mode: CUID?,
CURV, CURV?, ECUR, KCUR, and SCAL.
EMUL?
330 Emulation Mode Query
Input:
EMUL?[term]
Returned: <off/on >[term]
Format: n
FILTER
Input Filter Parameter Command
Input:
FILTER <input>, <off/on>, <points>, <window>[term]
a,n,nn,nn
Format:
<input>
<off/on>
<points>
<window> Specifies what percent of full scale reading limits the filtering function. Reading
Example: FILTER B,1,10,2[term] – Filter input B data through 10 readings with 2% of full scale
window.
FILTER?
Input Filter Parameter Query
Input:
FILTER? <input>[term]
Format: a
<input>
Returned: <off/on >, <points>, <window>[term]
Format: n,nn,nn
Remote Operation
Lake Shore Model 332 Temperature Controller User's Manual
Specifies field to query: 1 – 4.
(Refer to command for description)
Specifies whether 330 Emulation Mode is 0 = Off or 1 = On. Default = 0.
(Refer to command for description)
Specifies input to configure: A or B.
Specifies whether the filter function is 0 = Off or 1 = On.
Specifies how many data points the filtering function uses. Valid range = 2 to 64.
changes greater than this percentage reset the filter. Valid range = 1 to 10%.
Specifies input to query: A or B.
(Refer to command for description)
6-31