Dip-Switch Settings; Interlocked Functions - Magnetek Flex 12EX System Instruction Manual

4.2.4 Dip-Switch Settings

4.2.4.1 Interlocked Functions

Interlocked means the two adjacent push buttons cannot be activated simultaneously as
they will cancel each other out. Interlocked settings are usually applied to a crane's forward
and reverse motions. Each dip-switch on the decoder module corresponds to one (1)
motion or two (2) adjacent push buttons (refer to Fig. 14 & 15 below). Only the first seven
(7) dip-switch positions are used (counting from left to right). The 8
(far right) is not used.
1 2 3 4 5 6
(Fig. 14)
▇
Manufacture preset
Dip
Settings
0000000 Normal (single speed only, F2 & R2 relays not used)
Closed/Closed Relay Action at 2
0000001
Closed/Closed Relay Action at 2
0000010
Opened/Closed Relay Action at 2
0000011
0000110
On & Off affected by the e-stop command. When E-stop
0001000
On + Start / Off + Start -- Prior to pressing the button you must
0001001
first rotate and hold the power key switch at START position to
0001010
FWD/REV toggled (latched) and affected by the E-stop
0001011
0000111
0100001
0100010
0100011
7 8
Function Descriptions
relay)
relay)
relay)
On (right button) & Off (left button)
command is initiated, the Off relay is activated.
activate On or Off relays.
FWD/REV toggled (latched).
command.
Safety Magnet On & Off
Closed/Closed + Brake
Closed/Closed Relay Action + Brake
Opened/Closed Relay Action + Brake
RELAY FUNCTIONS
nd nd
Speed (separate 2 speed
nd nd
Speed (shared 2 speed
nd nd
Speed (separate 2 speed
Flex 12EX System Instruction Manual
th
dip-switch position
(Fig. 15)
# of Relays
Used
2
4
3
4
2
2
2
2
2
2
4
3
4
December 2013
Page 34 of 48