Web Browser Interface - FLIR Nexus Configuration Manual

2 Basic Operation and Configuration
2.4
Use a web browser to connect to the camera as described below, and confirm it is streaming video.
Once the bench test is complete, use the web browser to make configuration changes as needed (for
example, set the IP address to an address that is compatible with the existing network). It is also a
good idea to run the FSM software and confirm it is working with the camera as expected.
It is possible to log into the camera using one of three User Names: user, expert, and admin. 
By default all three accounts have the same password: fliradmin. The user login can be used to do
the initial bench test of the camera. The admin login must be used to make configuration changes
such as setting the IP address. The login passwords can (and should) be changed by the system
administrator to prevent unauthorized logins. For information on how to change the passwords, refer
to section 2.6 "Basic Camera Configuration" on page 2-10.
Log into the Camera Web Page
Step 1
Step 2
427-0030-00-28 Version 110

Web Browser Interface

Open a web browser and enter: http:\\192.168.250.116. The login screen with a picture of
the camera will appear. The example below shows the FC-Series camera.
Enter user for the User Name and fliradmin for the Password, and click Login.
Figure 2-1: Camera Web Page Login Screen
Jun 2013 2-3