FLIR Nexus Configuration Manual page 21

2 Basic Operation and Configuration
When the LAN settings are changed and the Save button is clicked, a pop-up message will appear to
indicate the network interface should be restarted.
Once all the changes have been made and saved, scroll to the bottom of the page and click on the
Restart Network button.
If the Hostname is changed, the new name may not show up in FSM until the camera is rebooted. To
reboot the camera, save any configuration changes, then select Server Status and click the Reboot
button.
Note
The IP address is temporarily displayed on the video for a short while after the camera boots up. If
you are unsure what the camera IP address is set to, it may useful to reboot the camera and watch
for the IP Address information after the camera boots up.
To reset the IP address to the factory default, refer to section 3.10 "Restoring the Factory Settings" on
page 3-18.
427-0030-00-28 Version 110 Jun 2013 2-13