Autopan Function - FLIR Nexus Configuration Manual

3 Advanced Configuration
Bits. Select the appropriate Hardware Protocol (RS-422 or RS-232), and set the Address parameter
to the appropriate Bosch address. If necessary, click Save to save the changes.
Note
Typical Bosch systems operate over a biphase connection and the FLIR cameras do not accept
biphase signals directly. It may be necessary to install a biphase converter in order to use the Bosch
protocol.
3.5.1
In many cases with a pan/tilt camera, it may be desirable to use a simple back-and-forth (left-right)
scan pattern, rather than a Scan List set of presets. To use the AutoPan feature (also known as Auto
Scan), set the left and right pan limits and the pan speed, and then start the AutoPan mode. The
functions for setting up the AutoPan limits and for controlling the AutoPan function are available using
presets and are described in the following table..
PRESET GOTO 90
PRESET GOTO 91
PRESET GOTO 92
PRESET GOTO 93
PRESET GOTO 94
PRESET GOTO 95
PRESET GOTO 96
PRESET GOTO 99
427-0030-00-28 Version 110

AutoPan Function

Table 3-1: AutoPan functions
GoToPanLimitLeft
GoToPanLimitRight
SetPanLimitLeft
SetPanLimitRight
IncrementAutoPanSpeed
DecrementAutoPanSpeed
StopAutoPan
StartAutoPan
Jun 2013 3-9