Installing Your Interface Card And Software - FLIR Oryx Installation Manual

3.2

Installing Your Interface Card and Software

1. Install your Interface Card
Open the Windows Device Manager. Ensure the card is properly installed. Ethernet cards appear under Network
Adapters. An exclamation point (!) next to the card indicates the driver has not yet been installed.
2. Install the Spinnaker® Software
a. Login to the
b. Select your Product Family, Camera Model and Operating System from the drop-down lists.
c. Click on the Software search results to expand the list.
d. Click the appropriate link to begin the download and installation.
After the download is complete, the Spinnaker setup wizard begins. If the wizard does not start automatically,
double-click the .exe file to open it. Follow the steps in each setup dialog.
3. For Ethernet cards: Enable jumbo frames
a. In Start->All Programs-> Point Grey Spinnaker SDK->SpinView, right click on the Network Adapter
and select Adapter Configuration, then select IP Configuration.
b. Click Open Network Connections.
c. Click Change Settings.
d. Click on the Advanced tab and from the Settings list select Jumbo Packet.
e. Set the Value to 9014 Bytes and click OK.
10/27/2017
©2017 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Ensure the card is installed per the manufacturer's instructions.
Connect the internal IDE or SATA power connector on the card to the computer power
supply.
Alternatively, use your PC's built-in host controller, if equipped.
Note: For existing users who already have Spinnaker installed,
we recommend ensuring you have the latest version for optimal
performance of your camera. If you do not need to install
Spinnaker, use SpinView to install and enable drivers for your
card.
Downloads page.
®
FLIR Oryx Installation Guide
3 Oryx Installation
4