FLIR Nexus Configuration Manual page 20

2 Basic Operation and Configuration
LAN Settings
The LAN Settings page can be used to set the hostname, default gateway, and IP address for the
camera. The default IP Address mode is static; the mode can also be set to DHCP. When the IP
address of the camera is changed, the PC may no longer be on the same network and therefore may
not be able to access the camera until the IP address on the PC is changed also. For that reason, it
may a good idea to change the IP address after making other configuration changes.
The LAN Settings page for the D-Series camera looks somewhat different, as there are two IP
Interfaces. The network address for the camera is interface eth0, and internally the camera
communicates using interface eth1.
Note
It is not possible to change the settings for Interface: eth1 with the web tool. Do not use an IP
address for the eth0 interface that is in the same network range as the eth1 IP address
(192.168.2.x). Contact FLIR Technical Support if it is necessary to use an address in that range for
the eth0 network interface.
2-12 427-0030-00-28 Version 110 Jun 2013