Ipv6 Neighbor Discovery Commands; Create Ipv6 Neighbor_Cache Ipif - D-Link xStack DGS-3400 Cli Manual

xStack
The following commands are used to detect IPv6 neighbors of the switch and to keep a running database about these neighbor
devices. The IPv6 Neighbor Discovery commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

create ipv6 neighbor_cache ipif

delete ipv6 neighbor_cache ipif
show ipv6 neighbor_cache ipif
config ipv6 nd ra ipif
config ipv6 nd ra prefix_option ipif
config ipv6 nd ns ipif
show ipv6 nd
Each command is listed, in detail, in the following sections.
create ipv6 neighbor_cache ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a static IPv6 neighbor:
D G S –3 4 26 :5 # c re a te i p v 6 n ei gh b o r_ c ac he i pi f T ri t o n 3 FF C: : 1 0 0 :0 1: 0 2 :0 3 :0 4: 0 5
C o m ma n d: c r e at e i pv 6 ne i gh bo r _ ca c he i p i f T ri to n 3F F C: :1 0 0: 0 1: 02 : 0 3: 0 4: 05
S u c ce s s.
D G S –3 4 26 :5 #
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
IP 6 N
V
Parameters
<ipif_name 12> <ipv6addr> <macaddr>
[<ipif_name 12> | all][<ipv6addr> |static |dynamic | all]
[<ipif_name 12> | all ] [ipv6address <ipv6addr> | static | dynamic |all]
<ipif_name 12> {state [enable | disable] | life_time <value 0–9000> |
reachable_time <value 0–3600000> | retrans_time <uint 0–4294967295> |
hop_limit <value 0–255> | managed_flag [enable | disable] | other_config_flag
[enable | disable] | min_rtr_adv_interval <value 3–1350> |
max_rtr_adv_interval <value 4–1800>} (1)
<ipif_name 12> <ipv6networkaddr> {preferred_life_time <uint 0–4294967295>
| valid_life_time <value 0–4294967295> | on_link_flag [enable | disable] |
autonomus_flag [enable | disable]} (1)
<ipif_name 12> retrans_time <uint 0–4294967295>
{ipif <ipif_name 12>}
Used to add a static IPv6 neighbor.
create ipv6 neighbor_cache ipif <ipif_name 12> <ipv6addr> <macaddr>
This command is used to add a static IPv6 neighbor to an existing IPv6 interface
previously created on the switch.
<ipif_name 12> – Enter the IPv6 interface name previously created using the create ipif
and config ipif commands.
<ipv6addr> – Enter the IPv6 address of the neighbor device to be added as an IPv6
neighbor of the IP interface previously entered in this command.
<macaddr> – Enter the MAC address of the neighbor device to be added as an IPv6
neighbor of the IP interface previously entered in this command.
Only Administrator and Operator-level users can issue this command.
D
EIGHBOR ISCOVERY
158
21
C
OMMANDS