Show Jwac Auth_State Ports - D-Link xStack DGS-3400 Cli Manual

xStack

show jwac auth_state ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display a JWAC host:
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to display JWAC client host information.
show jwac auth_state ports {<portlist>}
This command is used to display the information for JWAC client hosts.
If port 1 is in host-based mode:
(1) mac 00-00-00-00-00-01 is authenticated without VLAN assigned (may be the
specified target VLAN does not exist or the target VLAN has not been specified), the ID
of RX VLAN will be displayed (RX VLAN ID is 4004 in this example).
(2) mac 00-00-00-00-00-02 is authenticated with target VLAN assigned, the ID of target
VLAN will be displayed (target VLAN ID is 1234 in this example)
(3) mac 00-00-00-00-00-03 failed to pass authentication, the VID field will be shown as "-"
indicating that packets with SA 00-00-00-00-00-03 will be droped no matter which VLAN
these packets are from.
(4) mac 00-00-00-00-00-04 attempts to start authentication, the VID field will be shown as
"-" until authentication completed.
If port 2 is in port-based mode:
(1) mac 00-00-00-00-00-10 is the mac which made port 2 pass authentication, mac
address with "(P)" in the end indicats that this authentication is from a port in port-based
mode.
If port 3 is in port-based mode:
(1) mac 00-00-00-00-00-20 attempts to start authentication, mac address with "(P)" in the
end indicats the port-based mode authentication.
(2) mac 00-00-00-00-00-21 failed to pass authentication, mac address with "(P)" in the
end indicats the port-based mode authentication.
NOTE : In port-based mode, the VLAN ID field is displayed in the same way as host-
based mode
port – A port range to show the information of client host.
None.
333