Config Jwac Redirect; Config Jwac Virtual_Ip; To Configure The Jwac Redirect On The Switch - D-Link xStack DGS-3400 Cli Manual

xStack

config jwac redirect

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To configure the JWAC redirect on the Switch:

D G S –3 4 26 :5 # co n fi g j w ac re di r e ct de st i n at i on j w a c_ l og in _ p ag e d el a y _t i me 5
C o m ma n d: c o n fi g j wa c re d ir ec t _ d e st in a t io n j wa c _ lo g in _p a g e d el ay _ t im e 5
S u c ce s s.
D G S –3 4 26 :5 #

config jwac virtual_ip

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the JWAC virtual IP:
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to configure redirect destination and delay time before an unauthenticated host is
redirected to the Quarantine Server or the JWAC login Web page.
config jwac redirect {destination [quarantine_server | jwac_login_page] |
delay_time <sec 0–10>}
This command allows you to configure redirect destination and delay time before an
unauthenticated host is redirected to the Quarantine Server or the JWAC login Web
page.
The unit of delay_time is in seconds.
0 means there is no delay in redirection.
destination –To specify the destination which the unauthenticated host will be redirected
to.
delay_time – To specify the time interval after which the unauthenticated host will be
redirected.
Only Administrator and Operator-level users can issue this command.
Used to configure jwac virtual ipaddress. This IP is for accepting authentication request
from unauthenticated host.
config jwac virtual_ip <ipaddr>
The virtual IP of JWAC is for accepting authentication requests from unauthenticated
hosts. Only requests sent to this IP will get a valid response. This IP does not respond to
ARP requests or ICMP packets!
Do NOT set this IP on the same subnet as the client PC and the Switch's IPIF (IP
interface).
Note: the IP address being set shall NOT be identical to any devices in the network,
otherwise this will create problem to the original host holding that IP address.
<ipaddr> – To specify the IP address of the virtual IP.
Only Administrator and Operator-level users can issue this command.
324