Command History List - D-Link xStack DGS-3400 Cli Manual

xStack
The switch history commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
?
config command_history
show command_history
Each command is listed, in detail, in the following sections.
?
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display all of the commands in the CLI:
D G S –3 4 26 :5 # ?
. .
?
c l e ar
c l e ar ar pt a b le
c l e ar at ta c k _l o g
c l e ar co un t e rs
c l e ar fd b
c l e ar lo g
c l e ar po rt _ s ec u ri ty _ e nt r y po r t
c o n fi g 8 02 . 1 p d ef au l t _p r io ri t y
c o n fi g 8 02 . 1 p u se r_ p r io r it y
c o n fi g 8 02 . 1 x a ut h_ m o de
c o n fi g 8 02 . 1 x a ut h_ p a ra m et er p or t s
c o n fi g 8 02 . 1 x a ut h_ p r ot o co l
c o n fi g 8 02 . 1 x c ap ab i l it y p or t s
c o n fi g 8 02 . 1 x i ni t
c o n fi g 8 02 . 1 x r ea ut h
c o n fi g a cc e s s_ p ro fi l e p r of il e _ id
c o n fi g a cc o u nt
c o n fi g a dd r e ss _ bi nd i n g i p_ ma c ip a dd re s s
c o n fi g a dd r e ss _ bi nd i n g i p_ ma c po r ts
c o n fi g a dm i n l o ca l_ e n ab l e
c o n fi g a rp e n tr y
C T R L+ C E SC q Q u it
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Parameters
<value 1–40>
Used to display all commands in the Command Line Interface (CLI).
? {<command>}
This command is used to display all of the commands available through the Command
Line Interface (CLI).
{<command>} – Entering the question mark with an appropriate command will list all the
corresponding parameters for the specified command, along with a brief description of the
commands function and similar commands having the same words in the command.
None.
S P A CE n Ne x t P a ge
C
OMMAND
E N T ER Ne xt E nt r y
312
H
ISTORY
a A l l
40
L
IST