Create Igmp_Snooping Static_Group; Config Igmp_Snooping Static_Group - D-Link xStack DGS-3400 Cli Manual

xStack

create igmp_snooping static_group

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a static group 226.1.1.1 for VID 1:
D G S –3 4 26 :5 # c re a te i g m p_ s no op i n g s ta ti c _ gr o up v l a ni d 1 2 2 6 .1 . 1. 1
C o m ma n d: c r e at e i gm p _ sn o op in g st a ti c_ g r ou p v la n i d 1 2 26 . 1 .1 . 1
S u c ce s s.
D G S –3 4 26 :5 #

config igmp_snooping static_group

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add port 5 to static group 226.1.1.1 on VID 1:
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to create IGMP snooping static group information on the Switch.
create igmp_snooping static_group [ vlan <vlan_name 32> | vlanid <vidlist> ]
<ipaddr>
This command allows the creation of an IGMP snooping static group. Member ports can
be added to the static group. The static member and the dynamic member port form the
member ports of a group.
The static group will only take effect when IGMP snooping is enabled on the VLAN. For
those static member ports, the device needs to emulate the IGMP protocol operation to
the querier, and forward the traffic destined to the multicast group to the member ports.
For a layer 3 device, the device is also responsible to route the packet destined for this
specific group to static member ports.
The static member port will only affect V2 IGMP operation.
The Reserved IP multicast address 224.0.0.X must be excluded from the configured
group. The VLAN must be created first before a static group can be created.
vlan <vlan_name 32> − The name of the VLAN for which to create IGMP snooping static
group information.
vlanid < vidlist > − The list of the VLAN IDs for which to create IGMP snooping static
group information.
<ipaddr> − The static group address for which to create IGMP snooping static group
information.
Only Administrator and Operator-level users can issue this command.
Used to configure the current IGMP snooping static group on the Switch.
config igmp_snooping static_group [ vlan <vlan_name 32> | vlanid <vidlist> ]
<ipaddr> [ add | delete] <portlist>
This command is used to add or delete ports to/from the given static group.
vlan <vlan_name 32> − The name of the VLAN for which to configure IGMP snooping
static group information.
vlanid < vidlist > − The list of the VLAN IDs for which to configure IGMP snooping static
group information.
< ipaddr > − The static group address for which to configure IGMP snooping static group
information.
[ add | delete] <portlist> − Portlist to add or delete.
Only Administrator and Operator-level users can issue this command.
167