ZyXEL Communications XS-3900-48F User Manual page 312

Chapter 42 Configure Clone
The following table describes the labels in this screen.
Table 151 Management > Configure Clone
LABEL
Source/
Destination
Port
Basic Setting
Advanced
Application
Apply
Cancel
312
DESCRIPTION
Enter the source port under the Source label. This port's attributes are copied.
Enter the destination port or ports under the Destination label. These are the ports which
are going to have the same attributes as the source port. You can enter individual ports
separated by a comma or a range of ports by using a dash.
Example:
• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
• 2-6 indicates that ports 2 through 6 are the destination ports.
Select which port settings (configured in the Basic Setting menus) should be copied to the
destination port(s).
Select which port settings (configured in the Advanced Application menus) should be
copied to the destination ports.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XS3900-48F User's Guide