ZyXEL Communications XS-3900-48F User Manual page 171

Table 66 Advanced Application > VLAN Stacking > Selective QinQ (continued)
LABEL DESCRIPTION
SPVID SPVID is the service provider's VLAN ID (the outer VLAN tag). Enter the service provider ID (from
1 to 4094) for frames received on this port. See
information on VLAN ID.
Priority Select a priority level (from 0 to 7). This is the service provider's priority level that adds to the
frames received on this port.
"0" is the lowest priority level and "7" is the highest.
Add Click Add to save your changes to the Switch's run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Index This is the number of the selective VLAN stacking rule.
Active This shows whether this rule is activated or not.
Name This is the descriptive name for this rule.
Port This is the port number to which this rule is applied.
CVID This is the customer VLAN ID in the incoming packets.
SPVID This is the service provider's VLAN ID that adds to the packets from the subscribers.
Priority This is the service provider's priority level in the packets.
Delete Check the rule(s) that you want to remove in the Delete column and then click the Delete button.
Cancel Click Cancel to clear the Delete check boxes.
XS3900-48F User's Guide
Chapter 21 VLAN Stacking
Chapter 7 on page 81 for more background
171