ZyXEL Communications XS-3900-48F User Manual page 60

Chapter 4 The Web Configurator
bit and flow control set to none. The password will also be reset to "1234" and the IP address to
192.168.1.1.
To upload the configuration file, do the following:
Connect to the console port using a computer with terminal emulation software. See
1
page 51 for details.
Disconnect and reconnect the Switch's power to begin a session. When you reconnect the Switch's
2
power, you will see the initial screen.
When you see the message "Press any key to enter Debug Mode within 3 seconds ..." press
3
any key to enter debug mode.
Type atlc after the "Enter Debug Mode" message.
4
Wait for the "Starting XMODEM upload" message before activating XMODEM upload on your
5
terminal.
After a configuration file upload, type atgo to restart the Switch.
6
Figure 18 Resetting the Switch: Via the Console Port
Bootbase Version: V1.00 | 01/13/2011 19:34:13
RAM: Size = 524288 Kbytes
ZyNOS Version: V4.00(BVG.0)b6 | 01/28/2011 14:44:24
Press any key to enter debug mode within 3 seconds.
.....................................
Enter Debug Mode
ras> atlc
Starting XMODEM upload (CRC mode)....
CCCCCCCCCCCCCCCC
Total 393216 bytes received.
Erasing..
................................................................
OK
ras> atgo
The Switch is now reinitialized with a default configuration file including the default password of
"1234".
60
Section 3.2 on
XS3900-48F User's Guide