ZyXEL Communications XS-3900-48F User Manual page 153

Table 54 Advanced Application > Classifier (continued)
LABEL DESCRIPTION
VLAN Select Any to classify traffic from any VLAN or select the second option and specify the source
VLAN ID in the field provided.
Priority Select Any to classify traffic from any priority level or select the second option and specify a
priority level in the field provided.
Ethernet Select an Ethernet type or select Other and enter the Ethernet type number in hexadecimal
Type value. Refer to
Source
MAC Select Any to apply the rule to all MAC addresses.
Address
To specify a source, select the second choice and type a MAC address in valid MAC address format
(six hexadecimal character pairs).
Port Type the port number to which the rule should be applied. You may choose one port only or all
ports (Any).
Destination
MAC Select Any to apply the rule to all MAC addresses.
Address
To specify a destination, select the second choice and type a MAC address in valid MAC address
format (six hexadecimal character pairs).
Layer 3
Specify the fields below to configure a layer-3 classifier.
DSCP Select Any to classify traffic from any DSCP or select the second option and specify a DSCP
(DiffServ Code Point) number between 0 and 63 in the field provided.
IP Select an IP protocol type or select Other and enter the protocol number in decimal value. Refer
Protocol to
You may select Establish Only for TCP protocol type. This means that the Switch will pick out
the packets that are sent to establish TCP connections.
Source
IP Enter a source IP address in dotted decimal notation.
Address/
Specify the address prefix by entering the number of ones in the subnet mask.
Address
Prefix
Socket
Number
Destination
IP Enter a destination IP address in dotted decimal notation.
Address/
Specify the address prefix by entering the number of ones in the subnet mask.
Address
Prefix
Socket
Number
XS3900-48F User's Guide
Table 56 on page 154
Table 57 on page 155 for more information.
Note: You must select either UDP or TCP in the IP Protocol field before you configure the socket
numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option
and enter a TCP/UDP protocol port number.
Note: You must select either UDP or TCP in the IP Protocol field before you configure the socket
numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option
and enter a TCP/UDP protocol port number.
for information.
Chapter 18 Classifier
153