Table of Contents
Advertisement
BTC-BR User's Manual
2.4.9 – Programming
This item is divided into 05 (five) sub-items: Installation, Date-Time, Manufacturing Data,
Erase Memory and Software Version. For each sub-items there are others sub-items that will allow
programming of specific functions of MTCO.
2.4.9.1 – Installation
Steps
Contents of the display
1
4. CHECK K MEASUR
5. DEVICE TESTING
6. PROGRAMMING
5
6
(
) – Scroll
/
2
1. INSTALLATION
2. DATE - TIME
3. MANUFACT DATA
6
(
) – Scroll
1. READ PARAMETERS←
3
2. WRITE PARAMETERS
3. PROGRAMMING K
5
6
(
/
) – Scroll
READ PARAMETERS
4
READ OK!
1. READ PARAMETERS
5
2. WRITE PARAMETERS←
3. PROGRAMMING K
5
6
(
) – Scroll
/
WRITE PARAMETERS
6
WRITE OK!
1. READ PARAMETERS
7
2. WRITE PARAMETERS
3. PROGRAMMING K ←
5
6
(
) – Scroll
/
W ADJUST
8
* * *
[25054] P/Km
(E) – Ajustar
Keys
←
(E) Enter
←
E
(E) Enter
E
(E) Enter
(C) Exit
C
E
(E) Enter
(C) Exit
C
E
(E) Enter
* * *
(C) Sair
Procedures
Select Programming
This function will access a sub-menu in which
will be possible to make all necessary
adjustments to the operation of MTCO.
Select Installation
This function will access a sub-menu in which
will be possible to read and record all the
programmable parameters of MTCO, and to
program one by one, if necessary.
Select Read Parameters
In this function will be possible to read the
parameters necessary for programming a new
MTCO identical to the defective.
After completion of reading, the data
remain stored in the memory of the
programmer and can be recorded in other
unprogrammed MTCO.
Select Write Parameters
This function is a complement of the
previous. In this case the parameters are
recorded in the MTCO to be installed.
After completion of writing, the new MTCO is
able to be installed on the vehicle from which
the defective equipment was removed.
This function allows changing the constant of
correction "K" of the tachograph MTCO. This is
one of the parameters that the function "Read or
Save
Parameters"
keep
adjustment
is
necessary
understand the sign of speed from the sensor as
being the real.
In case of wanting to correct the constant "K",
press L to clear the fields of editing, enter the
desired value and press E. This adjustment is
similar to the installing a reducer in the
mechanical tachograph or adjustment of the keys
in the electronic tachograph.
in
memory.
This
for
the
MTCO
15
Advertisement
Table of Contents
