Table of Contents
Advertisement
BTC-BR User's Manual
Steps
Contents of the display
24
12. INITIAL INSTAL.
13. CALIBRATE DATE
14. SEAL NUMBER
5
6
(
) – Scroll
/
SEAL NUMBER
25
[SIEMENS VDO]
F1-SUB
(E) – Adjust
Note: In this function can be used the F1 key to help in the edition of the vehicle identification. This key
alternate the editing mode between overwrite or insert character. While on the screen of the
programmer the description F1-SUB the editing mode will allow to insert new characters erasing the
first from left to right. When is the function F1-INS, will be available the mode of replacement only
from the selected character. To enter the characters in yellow press F3 (from A to M), for the green
characters press F4 (from N to Z), and for numbers press F2 (from 0 to 9). At this moment the
corresponding led to the mode selected will remain on (for letters) or off (for numbers).
Steps
Contents of the display
26
13. CALIBRATE DATE
14. SEAL NUMBER
15. OVER SPEED
5
(
) – Scroll
OVER SPEED
27
[- - - -] km/h
READING MTCO
(E) – Adjust
28
OVER SPEED
[080] Km/h
(E) – Adjust
Note: the function "Over Speed" will be valid only for MTCO models that have, in their "Product
Code", the numbers 007 and 008 in position hhh (see Information Service T033/02).
Keys
←
E
(E) Enter
(C) Exit
Keys
←
E
(E) Enter
(C) Exit
(C) Exit
Procedures
Select Seal Number
Function of control. It records the number or
name of the person responsible for last
measurement of MTCO. Important function in
the
control
of
those
measurements made.
To record the desired information, press L to
clean the field of editing, enter the desired
name/number and press E. In case of wanting
replace only one character, press F1, select
the desired character and enter the new value
for it.
Procedures
Select Over Speed
This function allows adjusting the speed
from which a light or sound device could be
triggered, activated by the D4 output of
MTCO.
At this moment the calibrator will check what is
the value pre-adjusted to the MTCO. This will
be possible only if the tachograph have that
function.
After reading the pre-adjusted value will be
possible reprogram it.
In case of wanting to correct the trigger point of
the external device, press L to clean the field of
editing, enter the desired value and press E.
responsible
for
18
Advertisement
Table of Contents
