Table of Contents
Advertisement
BTC-BR User's Manual
Steps
Contents of the display
16
7. VEHICLE IDENT.
8. CONFIGURATION
9. CAN CONFIG.←
5
6
(
) – Scroll
/
10. PRODUCT CODE ←
17
11. DRIVE SHAFT
12. INITIAL INSTAL.
5
6
(
/
) – Scroll
10. PRODUCT CODE
18
11. DRIVE SHAFT
12. INITIAL INSTAL.
5
6
(
/
) – Scroll
DRIVE SHAFT
19
[00,01] I/U
(E) – Adjust
10. PRODUCT CODE
20
11. DRIVE SHAFT
12. INITIAL INSTAL.
5
6
(
) – Scroll
/
INITIAL INSTALLATION
21
[05 / 01 / 01]
F1 – Adjust
12. INITIAL INSTAL.
22
13. CALIBRATE DATE ←
14. SEAL NUMBER
5
6
(
/
) – Scroll
23
CALIBRATE DATE
[05 / 01 / 01]
F1 – Adjust
Keys
←
(E) Enter
(E) Enter
←
E
(E) Enter
(C) Exit
E
←
E
(E) Enter
(C) Exit
E
E
(E) Enter
(C) Exit
E
Procedures
These
functions
are
tachograph
currently in use. They are
included in the configuration of the product
and must not be changed in any hypothesis.
Select next function.
This function is not enabling to tachograph
currently in use. Modify since the configuration
of the display until the exhibition modes and
must
not
be
changed
circumstances.
Select next function.
Select Drive Shaft
This function records the relation of reduction
of the rear axle of the vehicle. Auxiliary
function in the mathematical calculation of the
constant"K".
In case of wanting to correct the relation of
reduction, press L to clean the field of editing,
enter the desired value and press E. This
programme is only informative, does not
affect the operation of the tachograph.
Select Initial Installation
Function of control. It records the date on which
the MTCO was installed. This function is
optional, however important in tracking the
product.
To register the Initial Installation, must be
pressed E to change the field, i.e., enter the day
and press E, enter the month and press E, and
finally enter the year and press E. At the end
press F1 and the date will be effective.
Select Calibrate Date
Function of control. It records the date on which
the measurement of MTCO was made. It is an
optional function, however important in the
tracking of the measurements by which the
MTCO passed.
To register the Calibrate Date, must be pressed
E to change the field, i.e., enter the day and
press E, enter the month and press E, and finally
enter the year and press E. At the end press F1
and the date will be effective.
not
enabling
to
under
any
17
Advertisement
Table of Contents
