Table of Contents
Advertisement
BTC-BR User's Manual
Steps
Contents of the display
9
4. N - ADJUSTMENT
5. WHEEL CIRCUMFER
6. DIST COUNTER
5
6
(
) – Scroll
/
4. N - ADJUSTMENT
10
5. WHEEL CIRCUMFER←
6. DIST COUNTER
5
6
(
) – Scroll
/
WHEEL CIRCUMFER
11
[5100] mm
(E) – Adjust
4. N - ADJUSTMENT
12
5. WHEEL CIRCUMFER
6. DIST COUNTER
5
6
(
/
) – Scroll
DISTANCE COUNTER
13
[0013586] Km
(E) – Adjust
7. VEHICLE IDENT.
14
8. CONFIGURATION
9. CAN CONFIG.
5
6
(
) – Scroll
/
VEHICLE IDENTIF.
15
[9BWV2VD23YRY03520]
F1-SUB
(E) – Adjust
Note: In this function can be used the F1 key to help in the edition of the vehicle identification. This key
alternate the editing mode between overwrite or insert character. While on the screen of the
programmer the description F1-SUB the editing mode will allow to insert new characters erasing the
first from left to right. When it is in the function F1-INS, will be available the mode of replacement
only from the selected character. To enter the characters in yellow press F3 (from A to M), for the
green characters press F4 (from N to Z), and for numbers press F2 (from 0 to 9). At this moment the
corresponding led to the mode selected will remain on (for letters) or off (for numbers).
Keys
←
(E) Enter
E
(E) Enter
(C) Exit
←
E
(E) Enter
(C) Exit
←
E
(E) Enter
E
(C) Exit
Procedures
This function is not enabling to tachograph
currently in use. It allows adjusting the
constant of adaptation to indication/recording
of engine speeds (RPM).
Select next function.
Select Wheel Circumference
In this function must be registered the
perimeter or radius of the wheel, with tire, from
the vehicle where the MTCO is installed.
Auxiliary
function
in
calculation of the constant"K".
In case of wanting to correct the value of the
perimeter/radius, press L to clean the fields of
editing, enter the desired and press E. This
programme is only informative, does not affect
the operation of the tachograph.
Select Distance Counter
This function allows programming the total
distance traveled in the equipments of
exchange and keeping them as the original
vehicle mileage.
In case of wanting to correct the kilometers
traveled, press L to clean the field of editing,
enter the desired value and press E.
This
function
allows
identification where the MTCO will be installed.
This function is an item of security and will help
in cases of traceability of equipment.
In case of wanting to correct the vehicle
identification, press L to clean the field of editing,
enter the desired value and press E. In case of
wanting to replace only one character, press F1,
select the desired character and enter the new
value for it.
the
mathematical
logging
the
vehicle
16
Advertisement
Table of Contents
