Installation/Built-In 60 Cm And 55 Cm; General; Water Installation - Electrolux GS 23 CH Service Manual

1.

Installation/Built-in 60 cm and 55 cm

1.1

General

- The dishwasher is supplied ready for
installation, i.e. with power cable, discharge
hose and admission hose with incorporated
sieve and sealing.
- Installation is at the connections provided for this
purpose in the adjacent cupboard (not directly
behind the appliance !).
- Observe the regulations of the local waterworks
and electrical power supply facilities !
- Do not lay down the appliance! The built-in
water softener contains water which could drain
off.
1.2

Water installation

Inlet :
- You can connect the appliance to both cold and
hot water (max. 50 °C).
- Water pressure: 1 to 10 bars
- A shut-off control element of connection ¾"
should be provided by the Customer.
- The inlet hose consists of high-quality plastic
with approved compressive and buckling
resistance. A sieve is incorporated on the
connection side to eliminate contamination from
the supply network, as well as a rubber seal.
- When making the connection, take care that
sieve and seal are in their correct positions.
- After opening the shut-off control, no water is
allowed to leak from the threaded joint !
- With hot water connection in particular, slightly
retighten the screwed joint after some minutes
of operation (do not use force) once the
connection has sufficiently heated up.
Drain:
- Install the flexible drainage hose without buckles.
- Installation is at the drain trap of the sink drain
pipe installed in the adjacent cupboard.
- The appliance is provided with a non-return
device which allows for installation height of the
appliance even above drain trap level.
- The highest point of the drainage hose may
never exceed the overall height of the appliance.
Spares Operation 07.02 A. B. - 5 - 599 51 13 34 EN