Electrolux GS 23 CH Service Manual page 60

... poor washing results in the upper basket
Cause
Central spray arm rotates too
slowly
Central spray arm is blocked
Miscellaneous
Cause
Tolerance position
Door hinge is jammed.
Leakages
Cause
Welding on the lower spray arm
is damaged.
Due to inappropriate fastening
screws, the dishwasher is drawn
apart on its upper part.
Wrong mounting of door seal
Spares Operation 07.02 A. B.
Problem
Drive nozzles are insufficient Exchange spray arm. Only
Lower basket wire bow is
bent back too far, detergent
cover opens too widely,
blocking the central spray
arm.
Upper basket wire bow
(limiting the load) is blocking
the central spray arm.
Problem
When pushing the lower
basket in, it could graze the
door sealing on the right or
left.
Door cannot be opened.
Problem
Water splashing over the
washing compartment apron.
Water or vapour leaking.
Seal is puckering in its elbows
on the top right and left side.
- 60 -
Solution
complete with connecting
pipe, PN 153 027 200/2
The new spray arm was
introduced as from
SNs 106 803 36 and
106 903 31 with the following
improved features:
- Improved rotational speed
by turboblades (change
from left-hand to right-
hand direction)
Bend the wire bow to the
front, as shown in the photo
above
Adjust wire bow.
Solution
The basket is better centred
in the washing compartment,
if you bend the second roller
from the rear a little to the
front.
Replace the hinge,
PN 153 025 101/4 L.H.
PN 153 025 102/2 R.H.
The hinge was modified as
from SNs 021 804 59 and
SN 021 904 49.
Solution
Replace spray arm,
PN 153 085 900/6
Only use original screw with
sleeve.
Sleeve
Observe mounting instructions.
599 51 13 34 EN