Setting The Rinsing Agent Dosage; Setting The Regenerating Salt Dosage - Electrolux GS 23 CH Service Manual

2. Setting the rinsing agent dosage

1. Open the dispenser by turning the cover cap (A)
to the left.
2. In order to increase the dosing amount, turn the
dosing arrow to the left by means of a coin or
screwdriver. In the works, the setting has been
to Position 3 (ideal setting is position 2 – 4).
3. Close the dispenser.
3.

Setting the regenerating salt dosage

Regenerating salt dosage for water softening should
be set to the respective water hardness degree. If you
set the dosage too low, calcium stains will be left
behind on the crockery and cutlery. Consult your
competent waterworks for information about the water
hardness and hardness range within your residential
area.
With a water hardness below 5 dH, there is no need
for filling any regenerating salt. In this incident, the salt
display is constantly lit.
Set the amount of dosage as follows :
Turn the dosing knob by means of a coin or
screwdriver until the arrow on the knob is directed to
the desired number (1 to 5):
The arrow should be directed to a number, and the
position should click into place.
Hardness range
IV
III
II
I
Spares Operation 07.02 A. B.
Water hardness in dH
> 28
22 28
15 21
8 14
5 7
< 5
- 13 -
Position
Rinsing cycles
5
4
3
2
1
1
No salt required
Number
10 15
18 22
25 30
30 40
40 60
599 51 13 34 EN