Computer Pretest - Electrolux GS 23 CH Service Manual

4.8

Computer Pretest

Application:
Start:
Key Stop:
Only 8-key / PNC
153 0259-06/6 and 7-
key / PNC 153 0259-
07/4
Stop (main switch):
Sequence:
Spares Operation 07.02 A. B.
This Pretest was developed for the test bench in the
works and can also be used in the field (best along with a
transparent door). All electrical components in the
machine are controlled.
Switch OFF main switch
Close door
The following key combinations are applicable for the following
control systems:
Press and hold
2 keys / PNC 153 0259-04/1: Programme selection (LED Eco
and intensive)
5 keys / PNC 153 0259-05/8: Eco and intensive
8 keys / PNC 153 0259-06/6 as well as
7 keys / PNC 153 0259-07/4: Stop and Short together
Switch ON main switch
Hold the key(s) pressed for at least 5 sec (corresponding LEDs
are flashing during this time)
The display shows the upper circle of the number 8 and/or the
corresponding LEDs are permanently lit
The programme starts to run
If you stop the programme by using the stop key, the green
LED Stop and Short will flash. Now you have to switch OFF
and ON again the control system, or elese no input is possible.
Attention: There is water in the machine !
If you start the pretest again - as described under Start - the
water contained in the machine is not pumped off. Depending
on the condition, the dishwasher now contains too much or too
little water.
If you stop the programme by means of the main switch, you
can immediately select a wash programme when switching ON
again.
If you start the pretest again - as described under Start - the
programme jumps directly to Step 9, first pumping the water off
the trough (corresponding LEDs flashing at the end).
Now you can restart the pretest - as described under Start.
See attached sequence plan.
- 22 - 599 51 13 34 EN