Electrolux GS 23 CH Service Manual page 34

Code E and/or END LED and/or Short are flashing:
- Maximum refilling time of 45 sec or maximal permitted number of 3 refills exceeded.
Possible causes:
Code H and/or END LED and/or Pre-rinse are flashing:
- Maximum heating time of 45 min exceeded, operating temperature not reached.
Possible causes:
Code L and/or END LED and/or Eco are flashing:
- Short-circuit or interruption at NTC temperature sensor.
Possible causes:
Code E2 (only displayed on 8-key electronic for 2 seconds after activation of main switch) :
- The appliance loses stored values in case of mains failure or when activating the main switch.
Cause:
This fault has no influence on the dishwasher functioning.
Note:
The two former fault messages P and U are no longer used in these control systems.
P (short-circuit level switch) has been newly incorporated into message C.
U (pump/cond. break or short-circuit) is cancelled, since, due to phase control, current monitoring is no
longer possible.
Spares Operation 07.02 A. B.
Fill-in hose does not allow enough water to pass through,
Sieves clogged
Water pressure too low, water tap or
Regeneration dosage (inlet elbow) calcified
Appliance loses water
heating damaged
heating relay damaged
80 °C safety thermostat disconnects the heating circuit too early or
in irregular manner
NTC sensor damaged
wiring of NTC sensor damaged
E2PROM in electronic system damaged
- 34 - 599 51 13 34 EN